Soapbox – General Blaster Care

Hello one and all,

Taking a moment of inspiration from our last game here. I had a relatively new member come up and ask me if I had any general suggestions about how he should best care for his blasters and darts. I quickly ran through a few points on the spot with him, but then figured it would probably make a pretty good topic to do a proper post on. So by that logic…

General Blaster Care!

1: Don’t leave blasters primed for an extended period of time.

Seems fairly self explanatory when you think about it, but don’t leave your blasters primed. All it will achieve it placing unneeded stress on the internals which will cause them to break/wear out faster. Leaving sprung blasters primed will also cost you range as the spring becomes used to the primed position as it’s natural state. An important point with this however is to take notice of the words ‘extended period of time’. By this I mean check your blasters before you go home at the end of a day, or even between games. Don’t worry about leaving it primed in game, the added benefit of being able to fire immediately is very useful. I’m sure some of you are giggling at this last point but I’ve genuinely seen players prime their blasters immediately before firing because someone told them it was bad to leave them primed.

 

2: Don’t dry fire sprung blasters.

Dry firing is where you prime and discharge the blaster without a dart in the barrel. This is particularly important with reverse plunger based blasters (Recon, Raider, Longstrike, Alpha Trooper, etc) but still applies to direct plunger based blasters. Dry firing places unnecessary strain on the internals. When you normally fire a sprung blaster, the air travels forward, hits the dart, begins to push it forward, but will still have some air remaining in the plunger tube to cushion the impact. With no dart, the air rushes out the barrel and gets no cushioning effect, smashing hard plastic together as hard as it possibly can.

 

3: Don’t leave darts in clips for an extended period of time.

I’m sure this has probably happened to most of you at some point as the darts are fairly noticeable. When you leave clips loaded for an extended period of time, the darts will become misshapen. The dart that was on top will end up with two indentations in line with the top of the clip, the ones underneath will become oval in shape. Both of these concerns will affect the seal between the dart and the chamber, and the inflight performance too. All in all, bad for your darts.

 

4: Don’t leave blasters in a car.

This is more relevant in warmer climates but still applicable to the cooler areas. The variances in temperature cause unnecessary stress on the plastics and can lead to premature failure.

 

5: Generally be nice to your blasters.

Try not to drop, throw, bang, etc. Should really go without saying but play nicely.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s